Order by Tue, Oct 20
Free shipping over $99
Ships from the USA
The dead wake in00:00:00:00

Deadhold Anchor Kit, 4 pack

$26.99$39.99

Deadhold Anchor Kit, 4 pack, studio packshot on white

Deadhold Anchor Kit, 4 pack

4.9(233)
$26.99$39.9933% off
  • 4 augers, straps, T-handle and hex bit
  • 18 in of spiral shaft per anchor
  • Winds in by hand or by cordless drill
  • Outdoor sod or clay on the front lawn
  • Nothing shows but the prop standing

Express checkout

  • Free U.S. shipping
  • 30-day returns
  • Secure checkout
Take it withExtra 30% off

Outdoor, 18 in, set of 4

The anchors that screw into the lawn instead of bending in it

Four 18-inch steel augers with a spiral shaft and a closed eye at the head. You wind them into sod or clay with the T-handle, or with the hex adapter chucked in a drill. Webbing straps with grommets run from the eye to the base of whatever you're holding down on the front lawn.

A spiral, not a pin

The shaft is a full auger, so it pulls itself down and threads through the soil instead of punching a hole. That is the difference between this and the bent wire pins that ship in the prop box.

Goes in with a drill, comes back out

The kit brings a T-handle and a hex driver adapter, so you can turn each anchor by hand or run it down with a cordless drill. The same tools back it out in November without digging.

Straps to the prop, not to the grass

Each anchor ends in a closed eye, and the flat webbing straps loop from that eye to a leg or a frame. Nothing shows from the sidewalk except the prop standing where you left it.

Deadhold Anchor Kit, 4 pack, closer in

Built for outdoors

Halloween night, then back in the tote

On the night, these are the part nobody looks at while the prop stays put through the wind coming off the street. In November you back them out with the same handle, coil the straps, and the whole set drops into the tote. Ships in 5 to 7 days, 3 to 4 on express.

  • 4 augers, straps, T-handle and hex bit
  • 18 in of spiral shaft per anchor
  • Winds in by hand or by cordless drill
What is in the box?

Four 18-inch steel augers, the webbing straps with grommets that run from each anchor to the prop, a T-handle for turning them, and a hex driver adapter for a cordless drill.

How long is each anchor?

Eighteen inches of spiral shaft, with a closed eye at the head. Most of that length is under the turf once it is wound down, so what is left showing is the eye and the strap.

How is this different from the pins that came with my prop?

The shaft is a full auger, not a bent pin. It pulls itself down and threads through the soil instead of punching a hole, so the load works against the soil around the whole shaft rather than against the top inch of it.

Do I need a drill?

No. The T-handle turns each anchor by hand. The hex adapter is there if you would rather run them down with a cordless drill, and the same tools back them out in November without digging.

How does it attach to the prop?

Each anchor ends in a closed eye, and the flat webbing straps loop from that eye to a leg or a frame. Nothing shows from the sidewalk except the prop standing where you left it.

Does it come back out?

Yes, with the same handle that put it in. Back them out, coil the straps, and the whole set drops into the tote instead of the trash.

The whole sheet

  • Height18 in
  • MotionStatic
  • UseOutdoor
  • MaterialSteel auger with webbing straps
  • Scare levelSlightly scary

Goes with it

You'll need this too

View all Anchoring & Hardware →
Recently on the block