Order by Tue, Oct 20
Free shipping over $99
Ships from the USA
The dead wake in00:00:00:00

Thornfield Bracket-Mount Spotlight

$39.99$69.99

Thornfield Phantom Projector, studio packshot on white

Thornfield Bracket-Mount Spotlight

4.7(338)
$39.99$69.9943% off
  • Flange plate screws to post or soffit
  • Side knob locks the tilt and swing
  • Cord out the back — wants a close outlet
  • No motor, no spin, no clicking
  • Porch eave, fence post or foundation

Express checkout

  • Free U.S. shipping
  • 30-day returns
  • Secure checkout
Take it withExtra 30% off

Corded, outdoor, bracket-mounted

The projector that cuts through streetlight glare

A black metal projector head on a jointed steel bracket, bolted to a round flange plate with screw holes around the rim. The cord runs out the back, so it wants a spot near an outlet: under a porch eave, on a fence post, low against the foundation. Aim it low and let the fog carry the beam.

Aim it once and it stays aimed

The joint under the barrel loosens with the side knob, tilts and swings where you point it, and locks there. Set the throw at dusk and it holds the same line all night.

It reads with the streetlight on

Bright enough to read through streetlight glare, so the image still lands on siding and fence board with the porch light and the street lamp both on. Check the throw from the sidewalk.

Screws down anywhere in the yard

The flange plate takes screws straight into a post, a soffit, or a scrap board sunk in the flower bed. Nothing on it spins or clicks. It lights, holds its aim, and stays out there for the whole run.

Thornfield Bracket-Mount Spotlight, closer in

Built for outdoors

After the 31st, it comes off in a minute

On Halloween night it does one job without asking for attention: no motor to jam, no sound to babysit. In November back the screws out, coil the cord around the barrel, and it goes back in the bin with the rest of the yard lights. Order early enough that standard shipping, 5 to 7 days, lands before the week of.

  • No stake here: the flange plate wants a post or a soffit
  • Takes screws, so budget a driver and five minutes
  • Low against the foundation is where it disappears
How does it mount?

The flange plate takes screws straight into a post, a soffit, or a scrap board sunk in the flower bed. There are screw holes around the rim.

Do I need tools?

Yes, a screwdriver or a drill for the flange plate. There is no ground stake on this one.

Does it need an outlet?

Yes. The cord runs out the back, so it wants a spot near power: under a porch eave, on a fence post, low against the foundation.

Will it hold the aim?

The joint under the barrel loosens with the side knob, tilts and swings where you point it, and locks there. Set the throw at dusk and it holds that line all night.

Does anything move or make noise?

No motor to jam and no sound to babysit. It lights, holds its aim, and stays out there for the whole run.

Will the image land with the porch light on?

It is bright enough to read through streetlight glare, so the image still lands on siding and fence board. Check the throw from the sidewalk.

The whole sheet

  • MotionStatic
  • PowerPlug-in 120V
  • UseOutdoor
  • MaterialMetal head on a steel bracket
  • Scare levelSlightly scary

Goes with it

You'll need this too

View all Lighting & Projection →
Recently on the block